You will not see your password as you are typing it just type it and press "Enter." You'll then be prompted for your password. At the login prompt, enter your username and press Enter. Switch to a TerminalĪt the login screen, press Ctrl+ Alt+ F5 to switch to a TTY. If you're unable to reach a Terminal, refer to the "Recovery" section below. One symptom of this situation, will be if the screen freezes on "cryptdata setup successfully" (pictured below): If your decryption passphrase is correct, but you're unable to reach the login screen, some of the packages that first run on login may need reinstalled. It's important to have current backups of your files to avoid data-loss. This is the cost/benefit of drives secured by encryption. In either case, unless you have set an alternative decryption key, the drive will need to be erased and re-imaged to regain acess. Your keyfile has been corrupted (rare).The decryption passphrase is incorrect.If entering your decryption passphrase does not unlock your disk, one of two things is likely the cause: Encryption Screen Issues Enryption Passphrase In most cases, you can switch to a full-screen terminal (called a TTY) to log in and fix the issue.
#STARTX BLANK SCREEN RASPBERRY PI DRIVER#
0 kommentar(er)
